Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTION SYSTEMJUNCTION BLOCKINSTALLATION
2003 Chrysler Intrepid SXT
Junction Block: Installation
2003 Chrysler Intrepid SXTSECTION Installation
- Install Junction Block/BCM to vehicle.
- Connect BCM wire connectors and RKE antenna connector.
- Install Junction Block/BCM.
- Install wire harness connectors to Junction Block/BCM.
- Install four mounting screws.
- Install under column ducts.
- Install left knee blocker.
- Connect cable to hood release, deck lid release switch wiring, and install two screws to lower instrument panel.
- Install left end cap.
- Connect the negative battery cable remote terminal to the remote battery post.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.