Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREAR WHEEL SPEED SENSORINSTALLATION
2003 Chrysler Intrepid SXT
Rear Wheel Speed Sensor: Installation
2003 Chrysler Intrepid SXTSECTION Installation
- Install rear wheel speed sensor and routing bracket into brake caliper adapter. Install head attaching bolt (Figure ) and tighten to 7 N.m (60 in. lbs.).
- Install the sensor cable to the routing bracket attached to the strut tower flange.
- Guide the cable through the hole in the floor pan and install the grommet.
- Install wheel and tire assembly on vehicle. Then torque all wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat tightening sequence to full specified torque of 129 N.m (95 ft. lbs.).
- Lower vehicle to the ground.
- Connect the sensor cable to the wiring harness.
- Reinstall the rear seat back and seat cushion.
- Road test vehicle to ensure proper operation of the base and ABS systems.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.