Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMFRONT WHEEL SPEED SENSORREMOVAL
2003 Chrysler Intrepid SXT
Front Wheel Speed Sensor: Removal
2003 Chrysler Intrepid SXTSECTION Removal
- Raise vehicle.
- Remove the tire and wheel assembly from the vehicle.
- Remove bolt securing the speed sensor cable routing bracket (Fig 1 ) to the strut assembly.
- Remove retainer holding the speed sensor sealing grommet from the inner fender. Pull the grommet out, then unplug the speed sensor cable from the vehicle wiring harness
CAUTION:
If speed sensor head locating pin has seized to the steering knuckle, Do not
attempt to remove speed sensor head by grasping with pliers and turning. This will damage the speed sensor head. Use only the following procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.