Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSISBODY & FRAMEPOWER WINDOWSWINDOW MOTORINSTALLATION
2003 Chrysler Intrepid SXT
Window Motor: Installation
2003 Chrysler Intrepid SXTSECTION Installation
- Install new motor on regulator by positioning motor gearbox so that it engages regulator sector teeth.
- A slight rotational or rocking movement may be necessary to bring three motor gearbox screw holes into proper position.
- Install three gearbox screws and one tie down bracket screw, if applicable. Tighten to 5.6 to 8 N.m (50 to 70 in. lbs.) torque.
- Install regulator. Using the switch, test operation of motor.
- Install trim panel. Refer to appropriate TRIM PANEL installation procedure.
- Connect the negative battery cable remote terminal to the to the remote battery post.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.