Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULESSENTRY KEY IMMOBILIZER MODULEINSTALLATION
2003 Chrysler Intrepid SXT
Sentry Key Immobilizer Module: Installation
2003 Chrysler Intrepid SXTSECTION Installation
NOTE:
If the SKIM is replaced with a new unit, a DRB III(R) scan tool and the BODY DIAGNOSTIC PROCEDURES
article MUST be used to initialize the new SKIM and to program at least two Sentry Key transponders.
- Slide the SKIM toward the steering column making sure the SKIM antenna ring is around the ignition cylinder housing (Figure ).
- Install the one screw securing the SKIM to the bottom of the steering column.
- Engage the steering column wire harness to the sentry key immobilizer Module (SKIM).
- Install the steering column upper and lower shrouds.
- Install knee blocker.
- Connect the negative battery cable remote terminal onto the remote battery post (Figure ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.