WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.

Monitored & Set Condition

When Monitored: While attempting to program RKE.
Set Condition: Lack of response from the RKE module while attempting to put it in program mode.

Possible Causes:

RKE Unable To Enter Program Mode

Testing

Turn ignition off. Replace Remote Keyless Entry (RKE) module. Connect scan tool to Data Link Connector (DLC). Using scan tool, clear Body Control Module (BCM) DTCs. Go to next step.
Using scan tool, attempt to program all RKE transmitters to be used with vehicle. See REMOTE KEYLESS ENTRY TRANSMITTER under PROGRAMMING. Using scan tool, retrieve BCM DTCs. If RKE UNABLE TO ENTER PROGRAM MODE DTC resets, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If RKE UNABLE TO ENTER PROGRAM MODE DTC does not reset, test is complete.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

RKE Unable To Enter Program Mode

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?