Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCK SYSTEMREMOTE KEYLESS ENTRY MODULEREMOVAL
2003 Chrysler Intrepid SE
Remote Keyless Entry Module: Removal
2003 Chrysler Intrepid SESECTION Removal
The Remote Keyless Entry (RKE) Module is located between the junction block and body control module. Refer to ELECTRONIC CONTROL MODULES .
- Disconnect and isolate the batter negative cable.
- With the junction block/BCM removed, separate the two by removing the four retaining screws.
- Unsnap the RKE module from the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.