Connect DRBIII® scan tool to Data Link Connector (DLC). See Figure. Place transmission in Park or Neutral. Turn the ignition on, with the engine off.
With DRBIII® scan tool, select THEFT ALARM, SKIM THEN MISCELLANEOUS.
Select PROGRAM IGNITION KEYS.

NOTE: A maximum of 8 keys can be learned by each SKIM at one time. Once a key is learned to SKIM, the key cannot be transferred to another vehicle.

Enter secured access mode by entering the vehicle 4-digit Personal Identification Number (PIN). Follow DRBIII® scan tool prompts. If ignition key programming is unsuccessful, the DRBIII® scan tool will display one of the following messages:
- Programming Not Attempted - The DRBIII® scan tool attempts to read the programmed key status and there are no keys programmed in the SKIM memory.
- Programming Key Failed - The SKIM is unable to program a key because it has a faulty transponder or the key is programmed to another vehicle.
- 8 Keys Already Learned, Programming Not Done - SKIM transponder identification memory is full. Obtain up to 8 keys to be programmed. Using the DRBIII® scan tool, erase all ignition keys by selecting MISC and ERASE ALL CURRENT IGN KEYS, then return to step 2.
- Learned Key In Ignition - Ignition key transponder identification is currently programmed in SKIM memory.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Programming Ignition Keys To SKIM