2003 Chrysler Intrepid ES, 3.5 VFACTORY OEM SERVICE PROCEDURE

Programming Powertrain Control Module

  1. To program PCM, connect DRBIII® scan tool to Data Link Connector (DLC). DLC is located below driver's side of instrument panel. See Figure. Place transmission in Park or Neutral. Turn the ignition on, with the engine off.
  2. Using DRBIII® scan tool, select THEFT ALARM, SKIM then MISCELLANEOUS.
  3. Select PCM REPLACED.
  4. NOTE: If 3 attempts are made to enter the secure access mode using an incorrect Personal Identification Number (PIN), secured access mode will be locked out for one hour (the vehicle will still run). To exit this lockout mode, turn the ignition switch to the RUN position for one hour then enter the correct PIN. (Ensure all accessories are turned off. Also, monitor the battery state and connect a battery charger if necessary).
  5. Enter secured access mode by entering the vehicle four-digit PIN.
  6. Press ENTER to transfer the secret key data (the SKIM will send the secret key data to the PCM).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.