2003 Chrysler Intrepid (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE

Crankshaft, Engine

Grade Marks / Crankshaft:

Factory service manual diagram




Crankshaft Main Bearing Journals
Diameter 63.49-63.51 mm (2.4997-2.5004 in.)
Bearing Clearance 0.035-0.053 mm (0.0014-0.0021 in.)
Bearing Clearance (Max.) 0.087 mm (0.0034 in.)
Out of Round (Max.) 0.015 mm (0.0006 in.))
Taper (Max.) 0.015 mm (0.0006 in.)
End Play 0.0475-0.2725 mm (0.0019-0.0108 in.)
End Play (Max.) 0.43 mm (0.017 in.)



Crankshaft Damper Bolt 170 Nm (125 ft. lbs.)



Grade Marks / Main Bearing:

Factory service manual diagram




Factory service manual diagram




Main Bearing Cap bolts
The main bearing cap bolts must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, and lastly the main cap tie (horizontal) bolts.

Install the inside main bearing cap bolts and tighten to 20 Nm (15 ft. lbs.) + 1/4 Turn (Fig. 51).

Measure crankshaft end play.
Install connecting rods and measure side clearance.

Factory service manual diagram




Install windage tray (Fig. 50). Lubricate bolts with engine oil and tighten to 27 Nm (20 ft. lbs.) + 1/4 Turn.

Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 in. lbs.) (Fig. 51).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.