Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler Intrepid (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE
Transmission Control Systems: Tools and Equipment
REQUIRED TOOLS AND EQUIPMENT
- Terminal Remover (Miller #3638)
- DRBIII (diagnostic read-out box) - Must be at latest release level.
- Transmissions Simulator (Miller # 8333,
- Electronic Transmission Adapter Kit (Miller # 8333-1A)
- Jumper wires
- Test Light ( minimum of 2. ohms self resistance)
- Ohmmeter
- Volt meter
- Pressure gauge (0-300 PSI
- Diagnostic Pin Out Box (Miller #881.
- Terminal Remover (Miller #3638)
- DRBIII (diagnostic read-out box) - Must be at latest release level.
- Transmissions Simulator (Miller # 8333,
- Electronic Transmission Adapter Kit (Miller # 8333-1A)
- Jumper wires
- Test Light ( minimum of 2. ohms self resistance)
- Ohmmeter
- Volt meter
- Pressure gauge (0-300 PSI
- Diagnostic Pin Out Box (Miller #881.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.