Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler Intrepid (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Tools and Equipment
DRBIII(R) (Diagnostic Read Out Box) scan tool
Evaporative System Diagnostic Kit #6917
Fuel filler adapter #8382
Fuel pressure adapter (C-6631) or #6539
Fuel pressure kit (C-4799-B) or #5069
Fuel release hose (C-4799-1)
Min Air flow fitting #6714
Pinout Box (Miller #8815)
Jumper wires
Ohmmeter
Oscilloscope
Vacuum gauge
Voltmeter
12 volt test light minimum 25 ohms resistance with probe #6801
CAUTION: A 12 volt test light should not be used for the following circuits, damage to the powertrain controller will occur.
- 5 Volt Supply
- 8 Volt Supply
- J1850 PCI Bus
- CCD Bus
- CKP Sensor Signal
- CMP Sensor Signal
- Vehicle Speed Sensor Signal
- O2 Sensor Signal
Evaporative System Diagnostic Kit #6917
Fuel filler adapter #8382
Fuel pressure adapter (C-6631) or #6539
Fuel pressure kit (C-4799-B) or #5069
Fuel release hose (C-4799-1)
Min Air flow fitting #6714
Pinout Box (Miller #8815)
Jumper wires
Ohmmeter
Oscilloscope
Vacuum gauge
Voltmeter
12 volt test light minimum 25 ohms resistance with probe #6801
CAUTION: A 12 volt test light should not be used for the following circuits, damage to the powertrain controller will occur.
- 5 Volt Supply
- 8 Volt Supply
- J1850 PCI Bus
- CCD Bus
- CKP Sensor Signal
- CMP Sensor Signal
- Vehicle Speed Sensor Signal
- O2 Sensor Signal
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.