WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.

Monitored & Set Condition

When Monitored: Continuously.
Set Condition: The BCM receives an indication from the RKE module that it has entered program mode without the BCM requesting so.

Possible Causes:

RKE Program Mode Entered Without Program Request

Testing

Turn ignition off. Connect scan tool to Data Link Connector (DLC). Replace Remote Keyless Entry (RKE) module. Using scan tool, program all RKE transmitters to be used with vehicle. See REMOTE KEYLESS ENTRY TRANSMITTER under PROGRAMMING. Go to next step.
Using scan tool, clear Body Control Module (BCM) Diagnostic Trouble Codes (DTC). Using RKE transmitters, lock and unlock vehicle several times. Using scan tool, retrieve BCM DTCs. If RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST DTC resets, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST DTC does not reset, test is complete.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

RKE Program Mode Entered Without Program Request

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?