2002 Chrysler Voyager ECFACTORY OEM SERVICE PROCEDURE

System Operation Check

  1. Ensure ignition key can only be removed from ignition switch with gearshift lever in Park.
  2. Ensure gearshift lever is in Park with gearshift lever handle in released position. Ignition switch should rotate freely from OFF position to LOCK position. Ignition switch should not rotate to LOCK position with gearshift lever in any other position.
  3. Shifting from Park should be possible when ignition switch is in OFF position and brake pedal is depressed.
  4. Shifting from Park should not be possible while pulling rearward on gearshift lever handle unless brake pedal is depressed with ignition switch in ON/RUN or START position.
  5. Gearshift lever should be locked in Park when ignition switch is in ACC or LOCK positions. Gearshift lever should be able to be moved into any position with ignition switch in OFF position.
  6. With ignition switch in ON/RUN or START position, gearshift lever should be able to be moved into any position including Park without depressing brake pedal.
  7. If system operation is not as specified, solenoid may be malfunctioning. Diagnose and repair as necessary. See SYMPTOM TESTS  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.