2002 Chrysler Voyager ECFACTORY OEM SERVICE PROCEDURE

DTC P0137: 1/2 O2 Sensor Shorted To Ground: Testing

NOTE: 1/2 HO2S may also be referred to as an downstream oxygen sensor. 1/2 HO2S is mounted on catalytic converter.
  1. Start engine and allow it to idle. Using scan tool, read 1/2 HO2S voltage. If voltage is less than .08 volt, go to next step. If voltage is .08 volt or more, go to step  7.
  2. Turn ignition off. Disconnect 1/2 HO2S connector. Start engine and allow it to idle. Using scan tool, read 1/2 HO2S voltage. If voltage is .08 volt or less, go to next step. If voltage is more than .08 volt, replace 1/2 HO2S.
  3. Turn ignition off. Ensure 1/2 HO2S is still disconnected. Disconnect PCM connectors. PCM is located on left side of engine compartment, near front of battery. Measure resistance between ground and Dark Blue/Yellow wire at 1/2 HO2S harness connector. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground in Dark Blue/Yellow wire between PCM and 1/2 HO2S.
  4. Measure resistance between Dark Blue/Yellow and Brown/Dark Green wires at 1/2 HO2S harness connector. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, Dark Blue/Yellow and Brown/Dark Green wires are shorted together. Repair wiring as necessary.
  5. Measure resistance between Dark Blue/Yellow and Brown/Light Green wires at 1/2 HO2S harness connector. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, Dark Blue/Yellow and Brown/Light Green wires are shorted together. Repair wiring as necessary.
  6. At this time, PCM is assumed to be defective. Replace PCM. Program the new PCM. See PROGRAMMING .
  7. At this time, conditions for DTC to set do not exist or fault is an intermittent problem. Start engine and allow it to idle. Ensure engine is at normal operating temperature. Using scan tool, monitor parameters related to DTC while wiggling connectors and wiring harness. If value changes while wiggling connectors and wiring harness, repair connectors and wiring harness where wiggling caused value to change. If value does not change, review Freeze Frame data using scan tool. Attempt to duplicate condition that caused DTC to set. Check for any related technical service bulletins that may apply. Visually inspect related connectors and wiring harness. Repair connectors and wiring harness as necessary. See WIRING DIAGRAMS article. If no problems are indicated, test is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.