Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
EVIC Internal Failure
Using scan tool, erase DTCs. Cycle ignition on and off several times leaving ignition on for approximately 15 seconds. Recheck for DTCs. If EVIC INTERNAL FAILURE resets, replace Electronic Vehicle Information Center (EVIC). See OVERHEAD CONSOLE under REMOVAL & INSTALLATION. If EVIC INTERNAL FAILURE does not reset, test is complete.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.