2002 Chrysler Voyager ECFACTORY OEM SERVICE PROCEDURE

No PCM Message Received (Active)

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition switch to ON position. Using scan tool, enter HVAC, then SYSTEM TESTS, then PCM MONITOR. If scan tool displays PCM ACTIVE ON BUS, replace HVAC control module. If scan tool does not display PCM ACTIVE ON BUS, go to next step.
  2. Using scan tool, attempt to communicate with Powertrain Control Module (PCM). If communications are established with PCM, go to next step. If communications cannot be established with PCM, diagnose concern with module communications network. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table.
  3. Turn ignition switch to OFF position. Disconnect PCM C2 connector. Connect Diagnostic Junction Port Tester (8339) to diagnostic junction port. DO NOT connect tester to scan tool. Measure resistance of PCI BUS circuit between diagnostic junction port test and PCM C2 connector. If resistance is less than 5 ohms, replace and reprogram NEW PCM. See POWERTRAIN CONTROL MODULE  under REMOVAL & INSTALLATION. If resistance is 5 ohms or more, repair PCI BUS circuit for an open condition as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.