Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Voyager ECFACTORY OEM SERVICE PROCEDURE
PCM Messages Not Received
NOTE:
After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.
- Turn ignition on. Using scan tool, select INSTRUMENT CLUSTER, SYSTEM TESTS then PCM MONITOR. If scan tool does not display PCM ACTIVE ON BUS, go to next step. If scan tool displays PCM ACTIVE ON BUS, erase DTCs and recheck. If DTC resets, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION.
- Using scan tool, attempt to communicate with Powertrain Control Module (PCM). If scan tool communicates with PCM, go to next step. If scan tool does not communicate with PCM, go to NO RESPONSE FROM PCM (PCI BUS) .
- Turn ignition off. Locate and disconnect PCM connectors. See COMPONENT LOCATIONS . Connect Diagnostic Junction Port Tester (8339) to diagnostic junction port. Using DVOM, measure resistance of White/Violet wire between diagnostic junction port terminal No. 6 and Body Control Module (BCM) connector C3 terminal No. 23. See Figure and Fig 1 . If resistance is 5 ohms or less, replace PCM. See POWERTRAIN CONTROL MODULE under REMOVAL & INSTALLATION. If resistance is greater than 5 ohms, repair open in White/Violet wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
