Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Compass Calibration Procedure (With Compass/Temperature Display Only)
Compass variance is the difference between magnetic north and geographic north. To adjust compass variance, press and hold C/T and US/M buttons until VAR = XX is displayed. Release buttons. XX indicates current variance setting. Press US/M button to select proper variance zone for your location. See Figure. Press C/T button to save new variance zone selection and resume normal operation.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.