Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Information Display
The CMTC/EVIC provides the following functions:
- Compass Direction
- Outside Temperature
- Elapsed Ignition On Time
- Distance To Empty
- Average Fuel Economy
- Instantaneous Fuel Economy
- Trip Odometer
- Distance To Service
The EVIC will also display the following driver alert messages:
- TURN SIGNAL ON (with vehicle graphic)
- PERFORM SERVICE
- DOOR OPEN (individual or multiple doors, with graphic)
- LOW or HIGH TIRE(S) PRESSURE (when equipped)
- ADJUSTABLE PEDAL DISABLED CRUISE ENGAGED (when equipped)
- ADJUSTABLE PEDAL DISABLED VEHICLE IN REVERSE (when equipped)
An audible chime or chimes will accompany any displayed warning messages. Chime requests with an OPEN message are dependent upon vehicle speed.
The CT/CMTC/EVIC will not display information for any of the screens for which it did not receive the proper PCI bus data.
The CMTC/EVIC receives the following messages from the Body Control Module (BCM):
- Verification Of US/Metric Status
- VF Display Dimming Brightness And Exterior Lamp Status
- Elapsed Ignition On Time Data
- Fuel Economy (Average And Instantaneous)
- Distance To Empty
- Distance To Service
- Driver Warning Messages
The CT/CMTC/EVIC receives the following message from the Front Control Module (FCM):
- Outside Temperature
The CMTC/EVIC receives the following messages from the Powertrain Control Module (PCM):
- Trip Odometer Data
- Vehicle Speed
The EVIC receives the following messages from the Adjustable Pedal System module (APS):
- APS Status Warnings
The CMTC/EVIC transmits the following messages to the BCM:
- Status Request: Beep, Reset, US/M Toggle
- Current Display
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
