2002 Chrysler ProwlerFACTORY OEM SERVICE PROCEDURE

Battery System: Battery: Removal

WARNING: TO PROTECT THE HANDS FROM BATTERY ACID, A SUITABLE PAIR OF HEAVY DUTY RUBBER GLOVES, NOT THE HOUSEHOLD TYPE, SHOULD BE WORN WHEN REMOVING OR SERVICING A BATTERY. SAFETY GLASSES ALSO SHOULD BE WORN.
  1. Verify that the ignition switch and all accessories are OFF.
  2. Open hood.
  3. Disconnect both negative and positive battery cable terminals from the battery posts. Make sure to disconnect the negative first (Fig. Fig 1).
    Fig 1: Identifying Battery Cables
    G01056917Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove one nut to battery hold down (Fig. Fig 2).
    Fig 2: Removing Battery Hold Down
    G01056918Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove battery from vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.