Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Window Switch: Operation
The driver door power window switch has an Auto-Down feature. The switch is equipped with two detent positions when actuating the power window OPEN. The first detent position allows the window to roll down and stop when the switch is released. The second detent position actuates and integral express roll down relay that rolls the window down after the switch is released.
The AUTO feature can be cancelled by actuating the switch UP or DOWN while the window is in motion.
A second power window switch in the driver side switch and bezel allows the driver to control the passenger side window. A Light Emitting Diode (LED) in the paddle of each switch is illuminated whenever the ignition switch is in the ON position.
The power window switches control the ignition and ground feeds to the power window motors.
The power door lock/window switch and bezel cannot be repaired and, if faulty for damaged, the entire switch and bezel must be replaced.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.