Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler PT Cruiser Base, StandardFACTORY OEM SERVICE PROCEDURE
Component Locations
WARNING: This page is about a different car, the 2002 Dodge Ram Wagon, 2002 Dodge Ram Van, 2001 Dodge Ram Wagon, and 2001 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Air Bag Control Module | On Bracket, Under Driver's Seat |
| Central Timer Module | Under Instrument Panel, On Left Center Support |
| Controller Anti-Lock Brake Module | On Top Of Hydraulic Control Unit Under Battery Tray |
| Data Link Connector | On Bottom Of Instrument Panel, To Left Of Steering Column |
| Fuse Block | On Left Instrument Panel End Bracket |
| Fuse/Relay Block | On Left Instrument Panel End Bracket |
| Hydraulic Control Unit | Under Battery Tray |
| Joint Connector No. 3 | Behind Left Side Of Instrument Panel |
| Key-In Ignition Switch Connector | On Right Side Of Steering Column, Next To Ignition Switch |
| Power Distribution Center | Next To Battery |
| Powertrain Control Module | On Firewall, Next To Wiper Motor |
| Wiper Motor Connector | On Bottom Of Wiper Motor, In Engine Compartment |
| Wiper Relay | Behind Top Of Glove Box |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
