2002 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

VTSS Verification Test

WARNING: This page is about a different car, the 2002 Dodge Ram Wagon, 2002 Dodge Ram Van, 2001 Dodge Ram Wagon, and 2001 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
  1. Close hood, tailgate and all doors. Open driver's side door. Remove ignition key. Lock doors using Remote Keyless Entry (RKE) transmitter. Close driver's side door. If Vehicle Theft Security System (VTSS) indicator flashes, system is functioning properly at this time. If VTSS indicator does not flash, go to next step.
  2. Using scan tool, clear Diagnostic Trouble Codes (DTC). Turn ignition off and wait 5 seconds. Turn ignition on. Using scan tool read DTCs from all modules. If any DTCs are present, go to DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and perform corresponding test(s). If no DTCs are present but customer complaint can be duplicated, go to SYMPTOM IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and repair by symptom. If no DTCs are present and customer complaint cannot be duplicated, repair is complete.
Chapter Navigation
Return to Chapter: Verification Tests
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.