Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Air Bag Control Module: Removal
WARNING: This page is about a different car, the 2002 Dodge Ram Wagon, 2002 Dodge Ram Van, 2001 Dodge Ram Wagon, and 2001 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect negative battery cable and wait 2 minutes. Reach under front of driver's side seat to access and remove molded plastic Air Bag Control Module (ACM) cover. ACM cover is secured to floor panel with double-faced foam tape. Discard ACM cover.
- Disconnect ACM connector. To disconnect ACM connector, remove Red Connector Position Assurance (CPA) lock from connector by sliding it toward front of vehicle. Depress connector latch tab and pull connector straight, away from ACM connector receptacle.
- Remove 3 ACM mounting screws that secure ACM to mount. Remove ACM and mounting bracket from vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
