2002 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Diesel Engine

  1. Position the battery in the vehicle.
  2. Connect the battery positive cable.
  3. Lift the battery retaining strap and install the battery in its tray.
  4. Install bolt and retainer that holds the battery down to the tray.
  5. Clip the vent tubing assembly on the battery retaining strap.
  6. Connect the vent tube assembly.
    WARNING: BE CERTAIN TO PROPERLY CONNECT THE BATTERY VENT SYSTEM. FAILURE TO DO SO COULD RESULT IN TOXIC FUMES BEING RELEASED INSIDE THE VEHICLES PASSENGER COMPARTMENT. REPLACE ANY PART OF THE VENT SYSTEM IF IT SHOWS ANY SIGNS OF WEAR, CRACKING, COLLAPSING, PUNCTURE OR ANY OTHER FORM OF IMPERFECTION.
  7. Connect the battery negative cable.
  8. Install the seat front trim panel.
  9. Install the two screws in the seat front trim panel.
  10. Close the passenger door.
  11. Verify operation of vehicle and systems.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.