Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
EATX Message Mismatch
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ under VERIFICATION TESTS.
- With the DRBIII, read DTCs. If the DRBIII displays EATX BUS MESSAGE NOT RECEIVED refer to the communications section of the symptom identification table for related symptoms. See SYMPTOM INDEXΒ table under SELF-DIAGNOSTIC SYSTEM. If the DRBIII does not display EATX BUS MESSAGE NOT RECEIVED, go to the next step.
- With the DRBIII in Cluster Type, ensure that the instrument cluster is correctly configured. If the instrument cluster is configured correctly, replace the instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in appropriate ANALOG INSTRUMENT PANELS article. If the instrument cluster is not configured correctly, with the DRBIII, configure the instrument cluster.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
