2002 Chrysler Neon LX, StandardFACTORY OEM SERVICE PROCEDURE

Fuel System Pressure Release

CAUTION: Fuel system is under high pressure. ALWAYS release fuel pressure before attempting to open system for testing or component replacement. DO NOT allow fuel to flow onto engine or electrical parts while testing fuel system components.
  1. Turn ignition off. Remove fuel pump relay from Power Distribution Center (PDC). See Figure . PDC is located in engine compartment. See Figure .
  2. Start engine and allow engine to idle until engine stalls. Attempt restarting engine until engine will no longer run. Turn ignition off.
  3. Place a shop towel under fuel line quick-connector at fuel rail. Use care when disconnecting fuel lines, as some fuel pressure may still exist in fuel lines. Disconnect fuel line quick-connector. Reinstall fuel pump relay in PDC.
  4. One or more Diagnostic Trouble Codes (DTC) may set when fuel pump relay is removed. Using scan tool, erase any DTCs that may have set after fuel pressure release procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.