Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE
VTSS Indicator Fails To Flash
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Ensure system is enabled before continuing. Turn ignition off. Disconnect 26-pin Remote Keyless Entry (RKE) module connector, located under center of instrument panel top cover. See Figure . Connect a jumper wire between RKE module connector terminal No. 17, Vehicle Theft Security System (VTSS) indicator driver circuit and ground. See Figure . If VTSS indicator does not illuminate, go to next step. If VTSS indicator illuminates, replace RKE module. See REMOTE KEYLESS ENTRY MODULEΒ under REMOVAL & INSTALLATION.
- Disconnect 26-pin instrument cluster connector, located behind left upper instrument panel. Using an ohmmeter, check resistance of VTSS indicator circuit between RKE module connector terminal No. 17 and instrument cluster connector terminal No. 5. See Figure . If resistance is less than 5 ohms, perform ANY PCI BUS INDICATOR INOPERATIVEΒ under INSTRUMENT CLUSTER. If resistance is 5 ohms or more, repair open wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
