Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE
Ambient Temperature Sensor Circuit Short
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
- Turn the ignition off. Disconnect the ambient temperature sensor harness connector. Measure the resistance of the ambient temperature sensor. See AMBIENT TEMPERATURE SENSOR RESISTANCE table. If the ambient temperature sensor resistance is within the min/max specifications, go to next step. If the ambient temperature sensor resistance is not within the min/max specifications, replace the ambient temperature sensor.
- Turn the ignition off. Disconnect and isolate the negative battery cable. Disconnect the ambient temperature sensor harness connector. Disconnect the compass/temperature mirror harness connector. Measure the resistance of the ambient temperature sensor signal circuit between the sensor connector and ground. If the resistance is less than 5.0 ohms, repair the ambient temperature sensor signal circuit for a short to ground. If the resistance is more than 5.0 ohms, go to the next step.
- Turn the ignition off. Disconnect and isolate the negative battery cable. Disconnect the ambient temperature sensor harness connector. Disconnect the compass/temperature mirror harness connector. Measure the resistance of the ambient temperature sensor ground circuit between the sensor connector and the compass/temperature mirror connector. If the resistance is more than 5.0 ohms repair the ambient temperature sensor ground circuit for an open. If the resistance is less than 5.0 ohms, replace compass/temperature mirror.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.