2002 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Foglight Indicator Inoperative

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn foglights on. If foglights are inoperative, repair as necessary. If foglights operate, turn ignition off. Disconnect 26-pin instrument cluster connector, located behind left upper instrument panel. Turn headlights and foglights on. Using a voltmeter, check voltage between instrument cluster connector terminal No. 4, foglight switch output circuit and ground. See Figure . If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair open on wire.
  2. Turn ignition off. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANELS article. Remove foglight Light Emitting Diode (LED) from instrument cluster. Using a DVOM, select DIODE mode. Connect DVOM Black lead to LED negative (-) terminal. Connect DVOM red lead to LED positive (+) terminal. If LED illuminates, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANELS article. If LED does not illuminate, replace defective LED.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.