Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Neon (CANADA) L4-2.0LFACTORY OEM SERVICE PROCEDURE
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL

The MAP sensor attaches to the intake manifold plenum.
1. Disconnect the electrical connector from the MAP sensor.
2. Remove sensor mounting screws.
3. Remove sensor.
4. Disconnect the negative battery cable.

5. Remove the electrical connector at the Manifold Absolute Pressure (MAP) sensor.
6. Remove 2 screws from sensor.
7. Remove sensor.
INSTALLATION
The MAP sensor attaches to the intake manifold plenum.
1. Insert sensor into intake manifold while making sure not to damage O-ring seal.
2. Tighten mounting screws to 4.5 Nm (40 in. lbs.) torque for plastic manifold.
3. Attach electrical connector to sensor.

4. Make sure that the manifold is clean.
5. Install sensor to manifold.
6. Tighten screws.
7. Connect the electrical connector to the sensor.
8. Connect the negative battery cable.
Fig.24 MAP Sensor:
The MAP sensor attaches to the intake manifold plenum.
1. Disconnect the electrical connector from the MAP sensor.
2. Remove sensor mounting screws.
3. Remove sensor.
4. Disconnect the negative battery cable.
Fig.25 MAP Sensor:
5. Remove the electrical connector at the Manifold Absolute Pressure (MAP) sensor.
6. Remove 2 screws from sensor.
7. Remove sensor.
INSTALLATION
The MAP sensor attaches to the intake manifold plenum.
1. Insert sensor into intake manifold while making sure not to damage O-ring seal.
2. Tighten mounting screws to 4.5 Nm (40 in. lbs.) torque for plastic manifold.
3. Attach electrical connector to sensor.
Fig.26 Intake Manifold/Map Sensor Location:
4. Make sure that the manifold is clean.
5. Install sensor to manifold.
6. Tighten screws.
7. Connect the electrical connector to the sensor.
8. Connect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
