Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid R/TFACTORY OEM SERVICE PROCEDURE
Driver Mirror Vertical Sensor Out Of Range High
NOTE:
After making any repairs, perform MEMORY HEATED SYSTEM VERIFICATION TEST
under VERIFICATION TESTS.
Monitored & Set Condition
- When Monitored: Ignition on.
- Set Condition: This code is set when the mirror sensor feedback to the MHSMM is greater than the mirror out of range high value stored in EEPROM.
Possible Causes:
- Driver Mirror Vertical Position Signal Wire Short To Voltage
- Driver Memory Mirror
- Memory Heated Seat Mirror Module
Testing
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) connector C1. Turn ignition on. Measure voltage on MHSMM connector C1 terminal No. 7, driver mirror vertical position signal circuit (Yellow/Orange wire). See Figure . If voltage is more than 4.5 volts, leave MHSMM connector C1 disconnected and go to next step. If voltage is 4.5 volts or less, replace MHSMM. See MEMORY HEATED SEAT/MIRROR MODULE under REMOVAL & INSTALLATION. If voltage is not 4.5-5.0 volts, leave MHSMM connector C1 disconnected and go to next step.
- Turn ignition off. Disconnect driver mirror connector. Turn ignition on. Measure voltage on driver mirror connector terminal No. 7, driver mirror vertical position signal circuit (Yellow/Orange wire). See Figure . If any voltage exists, repair short to voltage in Yellow/Orange wire. If no voltage exists, replace driver mirror. See POWER MIRRORS article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.