Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Ignition Interlock Cassette: Installation
NOTE:
Adjustment of interlock cassette is done during installation procedure.
- Ensure latch rotates freely on gearshift lever gate. Ensure gearshift lever is in Park. Remove ignition key. Install cable over hook on locking arm. Slide cassette into housing until it is locked in place. Push adjustment tab in until it stops. Adjustment tab will click as it moves into position. Ensure tab is fully depressed.
- Operate interlock system to confirm correct operation. See SYSTEM OPERATION CHECK under TROUBLE SHOOTING. Ensure ignition switch is prevented from being returned to LOCK or ACC positions unless gearshift lever is returned to Park. Key should only be able to be removed from lock cylinder with ignition switch in LOCK position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.