2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Final Drive: Disassembly

The valve body and solenoid wiring connector must be removed from the transaxle in order to service the transaxle differential. The transfer shaft cannot be removed with the valve body in place. Remove the valve body assembly from the transaxle. (Refer to VALVE BODYΒ )

  1. Remove transfer chain cover. See Fig 1.
    Fig 1: Removing Chain Cover
    G00993370Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove chain oiler. See Fig 2.
    Fig 2: Removing Chain Oiler
    G00993371Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove chain snubber. See Fig 3.
    Fig 3: Removing Chain Snubber
    G00993372Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove output shaft sprocket snap ring and wave washer. See Fig 4.
    Fig 4: Removing Output Shaft Sprocket Snap Ring & Wave Washer
    G00993373Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove transfer shaft sprocket snap ring and wave washer. See Fig 5.
    Fig 5: Removing Transfer Shaft Sprocket Snap Ring & Wave Washer
    G00993374Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.