Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Installation - Lower Control Arm
- Position tension strut in lower control arm as shown (Fig 1). Make sure the word FRONT which is stamped in tension strut, is positioned away from control arm.
- Install the washer and a NEW retaining nut on the end of the tension strut at the control arm. Place an open end wrench on flat of tension strut to keep it from turning tension while tightening retaining nut. Tighten retaining nut to a torque of 130 N.m (95 ft. lbs.).
- Install the lower control arm and tension strut assembly on the engine/suspension cradle in the following manner. Install tension strut and isolator bushing end into cradle first, then install lower control arm pivot bushing end into bracket on cradle (Figure).
- Install the lower control arm to cradle bracket attaching pivot bolt and nut (Figure). Do not tighten the lower control arm to cradle bracket attaching bolt at this time.
- Install washer on end of tension strut (Figure). Install a NEW
tension strut to cradle bracket nut, on tension strut (Figure). Tighten the tension strut to cradle bracket retaining nut to a torque of 130 N.m (95 ft. lbs.). When torquing tension strut nut, keep tension strut from turning by holding tension strut at flat using an open end wrench (Figure).CAUTION: Pulling steering knuckle out from vehicle after releasing from ball joint can separate inner C/V joint. See AXLE SHAFTS (2002) or AXLE SHAFTS (2003).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
