Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Drive Cycles

WARNING: This page is about a different car, the 2004 Chrysler Intrepid, 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

Manufacturer does not provide a specific drive cycle to run all the monitors. Performing Powertrain Verification Test VER-5 will run most of the monitors. See POWERTRAIN VERIFICATION TEST VER-5 under VERIFICATION TESTS. Verification tests are normally referred to after performing a code related diagnostic test. To run all the monitors, it may be necessary to perform more than one powertrain verification test. See appropriate POWERTRAIN VERIFICATION TEST under VERIFICATION TESTS.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.