2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

DTC P0532: A/C Pressure Sensor Low: Testing

    NOTE: Ensure the A/C system is properly charged with refrigerant.
  1. Start the engine. With the DRBIII®, read the A/C Pressure Sensor voltage. Is the voltage below 0.6 volt? If yes, go to next step. If no, go to step  10.
  2. Turn the ignition off. Disconnect the A/C Pressure Sensor harness connector. A/C pressure sensor has a Gray connector and is located on A/C discharge refrigerant line, near compressor. Turn ignition on, engine not running. Measure the voltage of the 5-Volt Supply circuit in the A/C Pressure Sensor harness connector. Is the voltage between 4.5 and 5.2 volts? If yes, go to next step. If no, go to step  7.
  3. With the DRBIII®, monitor the A/C Pressure Sensor voltage. Is the voltage above 0.6 volt? If yes, replace the A/C Pressure Sensor. If no, go to next step.
  4. Turn the ignition off. Disconnect the PCM harness connectors. Measure the resistance between ground and the A/C Pressure Sensor Signal circuit in the A/C Pressure Sensor harness connector. Is the resistance below 100 ohms? If yes, repair the short to ground in the A/C Pressure Sensor Signal circuit. If no, go to next step.
  5. Measure the resistance between the A/C Pressure Sensor Signal circuit and the Sensor Ground circuit in the A/C Pressure Sensor harness connector. Is the resistance below 100 ohms? If yes, repair the A/C Pressure Sensor Signal circuit for a short to the Sensor Ground circuit. If no, go to next step.
  6. NOTE: Before continuing, check the PCM harness connectors for corrosion, damage or terminal push out. Repair as necessary.
  7. There are no possible causes remaining, replace PCM. Program the new PCM. See PROGRAMMING .
  8. Turn the ignition off. Ensure A/C Pressure Sensor is disconnected. Disconnect the PCM harness connectors. Measure the resistance between ground and the 5-Volt Supply circuit in the A/C Pressure Sensor harness connector. Is the resistance below 100 ohms? If yes, repair the short to ground in the 5-Volt Supply circuit. If no, go to next step.
  9. CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal-to-pin connection. Use Miller Special Tool (8815) when performing diagnosis at PCM harness connectors.
  10. Measure the resistance of the 5-Volt Supply circuit from the A/C Pressure Sensor harness connector to the appropriate terminal at Miller Special Tool. Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the open in the 5-Volt Supply circuit.
  11. NOTE: Before continuing, check the PCM harness connectors for corrosion, damage or terminal push out. Repair as necessary.
  12. There are no possible causes remaining, replace PCM. Program the new PCM. See PROGRAMMING .
  13. NOTE: Ensure the A/C refrigerant System is properly charged
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.