2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Monitored & Set Conditions

MAP Sensor 5-Volt Supply circuit is monitored with the engine speed 600 to 3500 RPM, Throttle Position Sensor voltage less than 1.12 volts, and battery voltage greater than 10 volts. DTC will set when MAP sensor signal voltage is below 0.078 volt for 1.7 seconds with the engine running. DTC is a one trip fault.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.