Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Assembly - ICU
- Install the CAB (Figure ) on the HCU.
- Install the 4 bolts mounting the CAB (Figure ) to the HCU. Tighten the CAB mounting bolts to a torque of 2 N.m (17 in. lbs.).
- Plug the pump/motor wiring harness into the CAB (Figure ).
- Install the ICU in the vehicle. (Refer to INSTALLATION - ICU )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.