2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Automatic Day/Night Mirror

  1. Turn ignition switch on with transmission in Park. Press AUTO button to activate dimming feature. See Figure . Cover forward facing sensor with a dark cloth to exclude any ambient light.
  2. Shine a light into rear facing sensor. Observe whether or not mirror darkens. With mirror darkened, place transmission in Reverse. Mirror should return to normal. If mirror does not operate as specified, go to next step. If mirror operates as specified, system is operating correctly. Test is complete.
  3. Check for battery voltage between ground and mirror connector terminal No. 1 (Dark Blue/White wire) with ignition switch on. See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, repair open in Dark Blue/White wire between mirror connector and junction block. See WIRING DIAGRAMSΒ  .
  4. Check for continuity between ground and mirror connector terminal No. 2 (Black/Light Green wire). If continuity exists, go to next step. If continuity does not exist, repair Black/Light Green wire as necessary between mirror connector and junction block.
  5. Check for battery voltage between ground and mirror connector terminal No. 3 (Violet/Black wire) with transmission in Reverse. If battery voltage exists, replace mirror. See AUTOMATIC DAY/NIGHT INSIDE REARVIEW MIRRORΒ  under REMOVAL & INSTALLATION. If battery voltage does not exist, repair open in Violet/Black wire between mirror connector and junction block.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.