2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Removal & Installation

  1. Disconnect negative battery cable. Open driver's door. Pry off left instrument panel end cap. Remove 4 left side under-dash cover screws. Remove left side under-dash cover. Remove deck lid switch and wiring.
  2. Remove left knee bolster. Remove ducts under steering column. Disconnect connectors from junction block. Remove 4 junction block screws. Remove junction block. Disconnect BCM connectors. Remove Remote Keyless Entry (RKE) antenna connector (if equipped). Remove 4 RKE module-to-BCM screws. Remove RKE module. Remove 4 BCM-to-junction block screws. Separate BCM from junction block.
  3. To install, transfer RKE module to replacement BCM. To complete installation, reverse removal procedure. Program replacement BCM and enable VTSS. See BODY CONTROL MODULE  under PROGRAMMING.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.