Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Tire Pressure Verification Test
- Using a scan tool or the EVIC RESET button, set the EVIC to Diagnostics mode (blank screen).
- Set to EVIC as follows, press and hold the EVIC RESET button for 5 seconds (EVIC will beep). Set the EVIC to display BLOCK COUNTERS.
- A vehicle graphic will display showing counters at wheel locations.
- Drive vehicle at 25 MPH (40 KM/H) for at least 2 minutes.
- Observe that the counters increment at least 3 sensor/transmitter receptions for each wheel. Can the EVIC be trained and do the counters show Sensor/Transmitter receptions? If yes, repair is complete. If no, see DIAGNOSTIC TROUBLE CODE IDENTIFICATION table under SELF-DIAGNOSTIC SYSTEM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.