Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Wiper Not Wiping After Wash
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
Possible Causes:
- Wiper Operation
- Washer Pump Control Switch Output Circuit Open
- BCM
Testing
- Turn ignition on. Operate wipers in all speeds. If wipers operate properly, go to next step. If wipers do not operate properly, repair by symptom. Perform appropriate test under WINDSHIELD WIPER SYSTEM. See SYMPTOM IDENTIFICATION table under SELF-DIAGNOSTIC SYSTEM.
- Turn wipers off. Turn ignition off. Disconnect Body Control Module (BCM) connector C2. Turn ignition on. Connect a 12-volt test light between ground and BCM connector C2 terminal No. 7, washer pump control switch output circuit (Brown wire). See Figure . Monitor test light while pressing and releasing washer switch. If test light flashes, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If test light does not flash, repair open in Brown wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.