2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

VTSS Will Not Arm

NOTE: After making any repairs, perform VEHICLE THEFT SECURITY SYSTEM VERIFICATION TEST  under VERIFICATION TESTS.

Possible Causes:

  • Check The VTSS Status
  • Check The BCM For DTC's
  • Body Control Module - No Alarm Output

Testing

  1. Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, read THEFT ALARM status. If scan tool displays ENABLED, go to next step. If scan tool does not display ENABLED, enable Vehicle Theft Security System (VTSS).
  2. Using scan tool, retrieve Body Control Module (BCM) DTCs. If any DTCs exist, perform appropriate test. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM. If no DTCs exist, replace BCM. See BODY CONTROL MODULE  under REMOVAL & INSTALLATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.