Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Hazard Lights Fail To Flash
NOTE:
After making any repairs, perform VEHICLE THEFT SECURITY SYSTEM VERIFICATION TEST
under VERIFICATION TESTS.
Possible Causes:
- Verify Hazard Operation
- BCM - Hazards Inoperative With VTSS Alarm Tripped
Testing
- Turn hazard lights on. If hazard lights operate properly, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If hazard lights do not operate properly, go to next step.
- Turn hazard lights off. Substitute a known-good combination flasher. Turn hazard lights on. If hazard lights operate properly, replace combination flasher. If hazard lights do not operate properly, repair hazard lights as necessary. See EXTERIOR LIGHTS in appropriate SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.