Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
OTIS Messages Not Received
Monitored & Set Condition
- When Monitored: With the ignition in run and the IOD fuse installed.
- Set Condition: The BCM does not receive any messages from the Overhead Travel Information System (OTIS) for at least 14 seconds.
Possible Causes:
- Attempt To Communicate With The OTIS
- Body Control Module
Testing
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, attempt to communicate with Overhead Travel Information System (OTIS) module. If scan tool communicates with OTIS module, go to next step. If scan tool does not communicate with OTIS module, perform BUS +/- SIGNALS OPEN OR NO RESPONSE FROM OTIS/EVIC test.
- Using scan tool, clear DTCs. Turn ignition off. Turn ignition on and wait one minute. Using scan tool, retrieve DTCs. If OTIS MESSAGES NOT RECEIVED DTC resets, replace Body Control Module (BCM). See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If OTIS MESSAGES NOT RECEIVED DTC does not reset, fault may be intermittent. Check related wiring and connectors for poor connections or damage to wiring harness. See WIRING DIAGRAMS . Repair any problems found as necessary. If no problems are found, check if any Technical Service Bulletins (TSBs) apply to vehicle. If no TSBs apply, test is complete.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.