Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sun Sensor: Installation
- Connect the wiring harness connector to the sensor and position in the vehicle. Install the two sensor fasteners.
- Install the instrument panel top cover. See ANALOG INSTRUMENT PANELS - CONCORDE, INTREPID & 300M article. Connect the negative battery cable remote terminal to the remote battery post.
If the sensor does not protrude 1/4 inch, perform the following procedure:
- Confirm that the top cover is properly installed.
- Remove the top cover.
- Remove fasteners from sun sensor.
- Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher.
- Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15x1 inch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.