Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clutch Volume Index
An important function of the PCM is to monitor Clutch Volume Index (CVI). CVIs represent the volume of fluid needed to compress a clutch pack. The PCM monitors gear ratio changes by monitoring the Input and Output Speed Sensors. The Input or Turbine Speed Sensor sends an electrical signal to the PCM that represents input shaft RPM. The Output Speed Sensor provides the PCM with output shaft speed information. By comparing the two inputs, the PCM can determine transaxle gear position. This is important to the CVI calculation because the PCM determines CVIs by monitoring how long it takes for a gear change to occur.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
