Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chrysler Intrepid (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE
Brake Fluid: Service and Repair
STANDARD PROCEDURE - BRAKE FLUID LEVEL CHECK
Check master cylinder reservoir brake fluid level a minimum of twice a year.
Master cylinder fluid reservoirs for both standard and antilock brake systems are marked with a FULL fill line indicating the reservoirs proper fluid level.
NOTE: When filling brake fluid reservoir, use only Mopar brake fluid or an equivalent stored in a tightly sealed container. Brake fluid must conform to DOT 3 specifications. Do not use brake fluid with a lower boiling point than DOT 3, as brake failure could result during prolonged hard braking. Do not use petroleum-based fluid because seal damage in the brake system will result.
If necessary, add brake fluid to reservoir, bringing brake fluid level to the FULL fill line shown on fluid reservoir.
The master cylinder brake fluid reservoir used on this vehicle includes a brake fluid level switch. The brake fluid level sensor location is in the body of the brake fluid reservoir. In the event of low brake fluid level in the brake fluid reservoir, the RED brake warning indicator lamp in the instrument cluster will turn on.
Check master cylinder reservoir brake fluid level a minimum of twice a year.
Master Cylinder Fluid Level:
Master cylinder fluid reservoirs for both standard and antilock brake systems are marked with a FULL fill line indicating the reservoirs proper fluid level.
NOTE: When filling brake fluid reservoir, use only Mopar brake fluid or an equivalent stored in a tightly sealed container. Brake fluid must conform to DOT 3 specifications. Do not use brake fluid with a lower boiling point than DOT 3, as brake failure could result during prolonged hard braking. Do not use petroleum-based fluid because seal damage in the brake system will result.
If necessary, add brake fluid to reservoir, bringing brake fluid level to the FULL fill line shown on fluid reservoir.
The master cylinder brake fluid reservoir used on this vehicle includes a brake fluid level switch. The brake fluid level sensor location is in the body of the brake fluid reservoir. In the event of low brake fluid level in the brake fluid reservoir, the RED brake warning indicator lamp in the instrument cluster will turn on.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.